Kitchen Towel Hanger, continued

We've now finished the first 3 rows of the kitchen towel hanger:

Row 1: Sc 1 into cloth, *ch 2, sc 1 into cloth* to end.
Row 2: Turn, ch 2, sc 2 in each ch sp across, sc 1.
Row 3. Turn, ch3, dc in next st in previous row, *ch 1, skip 2, dc 1* across, dc 1.

The pattern will, in most likelihood, not work out exactly. So, you can fudge by skipping only 1 st before making the last two dc's of the row or else by ending dc, skip 1, dc.

The ch 2 at the beginning of Row 2 is a substitute for a sc. The ch 3 at the beginning of Row 3 acts as a substitute for a dc. The last st of Row 2 (and also Row 3) is made into the last of the ch sts that started the previous row.

To continue:
Repeat Rows 2-3 until there are somewhere around 10 sts across (between 9 and 15), ending with a Row 3. The picture shows the first repeat of Row 2. The first of 2 sc's is being worked into a ch sp.

Then, we will switch to a different kind of mesh. This mesh doesn't have sc's in alternate rows (which gave the piece the sturdiness needed due to a rapid decrease in width). Instead, each row of the next mesh will have dc's and chain spaces only -- and will keep the same width.

Row 1: Turn, ch 3, *ch 1, skip 1, dc 1* across.
The ch 3 at the beginning of the row serves as a substitute for a dc. The ch 1 creates a ch sp (chain space). So, even though the row starts out with 4 ch sts, it's really a dc substitute plus a ch.
Row 2: Turn, ch3, dc 1, *ch 1, skip 1, dc 1* across, dc 1.
The last dc of the row is made into the last of the 3 ch sts that served as a substitute for a dc in the previous row. The rest of the dc's can either be made into a chain space or into a ch st (whichever, as long as it's consistent). It's much easier to dc into a ch sp than into a ch st.

Repeat these 2 rows for around 5".

For the next step, we'll decrease again -- in preparation for a buttonhole. The next post discusses decreasing, in general terms. The post after that will be on the buttonhole.